Application Instructions

Your pet's wardrobe is about to get cooler. 😎

 

Follow the instructions below for how to apply your vinyl stickers or iron-on's to any product you own.

 

Vinyl Sticker Application Instructions:

What you'll need:

1. Alcohol wipe or Isopropyl alcohol

2. Desired surface for application

3. Credit Card (sorry, we’ll need this again 😜)

4. Vinyl Sticker

 

Instructions:

1. Wipe down your surface with an alcohol wipe or a spritz of isopropyl alcohol and allow the surface to dry.

2. Remove the white backing liner from your sticker at a 45 degree angle.  If the sticker does not completely separate from the white backing, simply press the transfer tape back down on the backing and use your Credit Card to smooth over the sticker. Attempt to peel away again and repeat process if necessary.

3. Once the white backing is removed, hold both ends of the transfer tape and apply your sticker to your surface starting in the middle.

4. Use your Credit Card to smooth both ends from the middle outwards, working to remove any bubbles.

5. Once applied and most bubbles are removed, peel back the transfer tape slowly at a 45 degree angle.

(Any remaining air bubbles should disappear within 24 hours)

 

 

Iron-on Application Instructions:

What you'll need:

1. Your iron-on transfer (Seperate layers if your design is a Layered Iron-On, i.e more than one vinyl colour.)

2. Desired garment for application

3. A sheet of Kraft paper or non-stick cover sheet (baking paper works great 😃)

**Applies best to 100% cotton, Poly/Cotton blends, 100% polyester and Leather**

Preparation:

Make sure your garment is pre-washed and dried.

**If you are unsure of your garment's make-up, set your iron to low-medium heat setting**

Instructions:

1. Set iron dial between Cotton and Linen

2. Iron your garment to ensure it is flat and free from moisture.

3. If your iron-on design is layered, peel apart layers and follow below steps for each layer individually

3. Cover design with Kraft paper or non-stick cover sheet

4. Press iron with medium/firm pressure (do not slide iron) and press each section for 10-15 seconds

5. Transfer sheet will be 🔥 HOT. Allow transfer to cool then peel back gently at a 45 degree angle. If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds.

6. If your design is layered, repeat steps 3-5 with each layer individually.

7. Strut your stuff at the dog park so everyone knows who is the coolest pup in town.😎

Washing:

Wait 24 hours before 1st wash
Machine wash warm or cold / mild detergent
Dry on normal dryer setting
Do not dry clean

 

Big Dog & Skippy takes no responsibility for damage caused to your goods when applying our vinyl stickers or iron-on's.